The Swiss company Microcut's MicroTest HS-P contact plug tester mainly tests bare plugs (outer diameter: 1.0mm to 3.2mm) and sleeves. The testing parameters include concentricity, roundness, plug center hole angle, and other parameters

Features
• Increase throughput
• Measure under industrial condition close to fabrication
• Minimized setup and calibration time (assisted setup)
• Maximized reliability and accuracy (less re- testing and comparison testing)
• choose specific machine fitting your needs
• Improve reliability and accuracy of measurement
• Dirt tolerant tactile measurement
• Measure close to function (Measure inside the bore at defined depth of termination)
• Document your measuring results automatically and easily
• Make sharp margins in between categories
• Use the market reference measuring machine
• The angle of the lD has at the concentricity a significant impact onthe performance of an FO Ferrule
• Analyse your injection mould tool before producing bad blanks
• Detect blanks-problems before machining them costly
• Detect iD angle problems on your Ferrule before terminate the connector costly